Starting and Stopping | Husqvarna SMC 50 EF specs

STARTING AND STOPPING

!WARNING!

Observe the following before star- ting the engine:

•The engine must be mounted in the sawmill before starting. Otherwise the clutch can come loose and cause personal injuries.

•Keep people and animals well away from the risk zone.

Starting a cold chain saw engine (FIG. 38)

A cold engine is started as follows:

1.Read through the operator’s manual for the chain saw carefully and make sure you understand it before attempting to start the chain saw.

2.Set the stop button to the start position.

3.Pull out the choke. When the choke is pulled out the throttle valve is automatically set in the start throttle position.

4.For other operation, see the chain saw operator’s manual.

FIG. 38

Stopping the chain saw engine (FIG. 39)

The engine is stopped by setting the stop button to the stop position.

FIG. 39

English – 23

Image 23

Husqvarna SMC 50 EF manual Starting and Stopping, Starting a cold chain saw engine FIG, Stopping the chain saw engine FIG

Contents

English SMC 50 SMC 50 E SMC 50 EF Table of Contents Introduction Introduction Symbols KEY to Symbols Personal Protective Equipment Safety RegulationsSafety Regulations Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During Use One-man sawmill chain saw engine Description One-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIG Feed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIG Electric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIG Folding Stops C Height Adjustment BRails Log Bolsters a Rail Guard Adjustable Support FeetRail Stop Safety Devices Unpacking InstallationInstallation Installation Site Saw Carriage Adjustment FIG Setting up the Saw Carriage FIG One-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engine Install throttle and cable FIG Install scale pointer and scale FIGInstall the handlebar FIG Checking the bar Adjusting the bar Petrol Fuel HandlingFuel chain saw engine Fuelling Two-stroke oilMixing Stopping the chain saw engine FIG Starting and StoppingStarting a cold chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIG Securing the Log USE Sawing Calculating the Yield Starting the Electric Motor Starting the Petrol Engine Edging FIG Clutch drum Maintenance Saw chain Drive belt Saw unit’s height adjustment Monthly maintenance MaintenanceDaily maintenance Weekly maintenance Technical data Technical Data EU Declaration of Conformity only applies to Europe Noise LevelsVibration Levels Page 2004W12 114 02