One-man Sawmill Electric Motor | Husqvarna SMC 50 EF specs

DESCRIPTION

One-man Sawmill Electric Motor

The one-man sawmill consists of two main parts:

•The carriage with motor and saw

•Rails

1.Rail sections (2)

2.Log lifter

3.Timber supports (short and long)

4.Log bolster

5.Log lock

6.Adjustment nut

7.Saw carriage

8.Protective loop

10.Skid rail

11.Idler adjustment screw for saw height

12.Height setting lock

13.Underlying support wheel

14.Scale pointer with scale

15.Indicator

16.Handlebars

20.Support foot

21.Scraper

22.Rail stop

23.Machine plate

24.Bar and chain

25.Oil tank

26.Motor console

27.Connector with phase inverter

28.Electric motor

29.Start button electric motor

32.Stop button electric motor

37.Safety switch

Tools and operator’s manual

A. Open ended spanner 13-15 mm

B. Open ended spanner 17-19 mm

C. Socket spanner

D. Combination spanner 13-19

E. Combination spanner

F. Allen key 6 mm

G. Allen key 4 mm

H. This operator’s manual

8 – English

Image 8

Husqvarna SMC 50 EF manual One-man Sawmill Electric Motor

Contents

SMC 50 SMC 50 E SMC 50 EF English Table of Contents Introduction Introduction KEY to Symbols Symbols Personal Protective Equipment Safety RegulationsSafety Regulations One-man Sawmill Safety Equipment Fuel SafetySafety During Use Risk Zone Description One-man sawmill chain saw engine One-man Sawmill Electric Motor One-man sawmill with electric motor and feed Height Setting FIG Saw carriage FIGFrame and FIG Handlebars FIG Chain oil tank FIG Vibration damping plate for the chain saw FIGBar and chain FIG Feed unit for chain sawmill with electric motor FIG Motors Chain saw engine FIGElectric Motor FIG Electric motor feed unit FIG Height Adjustment B RailsLog Bolsters a Folding Stops C Rail Guard Adjustable Support FeetRail Stop Safety Devices Installation InstallationInstallation Site Unpacking Setting up the Saw Carriage FIG Saw Carriage Adjustment FIG Install chain saw and bar FIG Install the bar FIGOne-man sawmill with chain saw engine One-man sawmill with electric motor Install throttle and cable FIG Install scale pointer and scale FIGInstall the handlebar FIG Adjusting the bar Checking the bar Petrol Fuel HandlingFuel chain saw engine Fuelling Two-stroke oilMixing Stopping the chain saw engine FIG Starting and StoppingStarting a cold chain saw engine FIG Starting the electric sawmill FIG Starting the electric sawmill with feed FIG USE Securing the Log Calculating the Yield Sawing Starting the Petrol Engine Starting the Electric Motor Edging FIG Maintenance Clutch drum Saw chain Saw unit’s height adjustment Drive belt Maintenance Daily maintenanceWeekly maintenance Monthly maintenance Technical Data Technical data EU Declaration of Conformity only applies to Europe Noise LevelsVibration Levels Page 114 02 2004W12