Description, One-man sawmill chain saw engine | Husqvarna SMC 50

DESCRIPTION

One-man sawmill chain saw engine

The one-man sawmill consists of two main parts:

•The carriage with engine and saw

•Rails

1.Rail sections (2)

2.Log lifter

3.Timber supports (short and long)

4.Log bolster

5.Log lock

6.Adjustment nut

7.Saw carriage

8.Protective loop

9.Vibration damping plate

10.Skid rail

11.Idler adjustment screw for saw height

12.Height setting lock

13.Underlying support wheel

14.Scale pointer with scale

15.Indicator

16.Handlebars

17.Throttle

18.Throttle lock

19.Throttle cable

20.Support foot

21.Scraper

22.Rail stop

23.Machine plate

24.Bar and chain

Tools and operator’s manual

A. Open ended spanner 13-15 mm B. Open ended spanner 17-19 mm C. Socket spanner

D. Combination spanner 13-19 E. Combination spanner

F. Allen key 6 mm G. Allen key 4 mm

H. This operator’s manual

English – 7

Image 7

Husqvarna SMC 50 EF manual Description, One-man sawmill chain saw engine

Contents

English SMC 50 SMC 50 E SMC 50 EF Table of Contents Introduction Introduction Symbols KEY to Symbols Safety Regulations Safety RegulationsPersonal Protective Equipment Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During Use One-man sawmill chain saw engine Description One-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIG Feed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIG Electric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIG Folding Stops C Height Adjustment BRails Log Bolsters a Rail Stop Adjustable Support FeetRail Guard Safety Devices Unpacking InstallationInstallation Installation Site Saw Carriage Adjustment FIG Setting up the Saw Carriage FIG One-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engine Install the handlebar FIG Install scale pointer and scale FIGInstall throttle and cable FIG Checking the bar Adjusting the bar Fuel chain saw engine Fuel HandlingPetrol Mixing Two-stroke oilFuelling Starting a cold chain saw engine FIG Starting and StoppingStopping the chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIG Securing the Log USE Sawing Calculating the Yield Starting the Electric Motor Starting the Petrol Engine Edging FIG Clutch drum Maintenance Saw chain Drive belt Saw unit’s height adjustment Monthly maintenance MaintenanceDaily maintenance Weekly maintenance Technical data Technical Data Vibration Levels Noise LevelsEU Declaration of Conformity only applies to Europe Page 2004W12 114 02