Starting the Petrol Engine | Husqvarna SMC 50 EF specification

USE

!WARNING!

Check during sawing that the chain does not hit the folding stops or log lock.

!WARNING!

The saw carriage must not be moved backwards while the chain is in motion. The log could come loose and cause personal injury.

Starting the Petrol Engine

1.Start the engine. See page 23.

Starting the Electric Motor

1.Start the electric motor. See page 24.

Sawing

2.Move the saw carriage forwards and cut off the sapwood.

3.Remove the sapwood.

4.Loosen the log, turn it 180°, lower the height adjuster (B), and secure the log.

5.Set the required cutting height using the height adjustment crank (11). This determines the width of the board.

6.Cut off the sapwood on the other side. See p 2 and 3.

FIG. 47

FIG. 48

English – 27

Image 27

Husqvarna SMC 50 EF manual Starting the Petrol Engine, Starting the Electric Motor

Contents

English SMC 50 SMC 50 E SMC 50 EF Table of Contents Introduction Introduction Symbols KEY to Symbols Safety Regulations Safety RegulationsPersonal Protective Equipment Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During Use One-man sawmill chain saw engine Description One-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIG Feed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIG Electric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIG Folding Stops C Height Adjustment BRails Log Bolsters a Adjustable Support Feet Rail StopRail Guard Safety Devices Unpacking InstallationInstallation Installation Site Saw Carriage Adjustment FIG Setting up the Saw Carriage FIG One-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engine Install scale pointer and scale FIG Install the handlebar FIGInstall throttle and cable FIG Checking the bar Adjusting the bar Fuel Handling Fuel chain saw enginePetrol Two-stroke oil MixingFuelling Starting and Stopping Starting a cold chain saw engine FIGStopping the chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIG Securing the Log USE Sawing Calculating the Yield Starting the Electric Motor Starting the Petrol Engine Edging FIG Clutch drum Maintenance Saw chain Drive belt Saw unit’s height adjustment Monthly maintenance MaintenanceDaily maintenance Weekly maintenance Technical data Technical Data Noise Levels Vibration LevelsEU Declaration of Conformity only applies to Europe Page 2004W12 114 02