Husqvarna Z4818BIA/968999250 manual To level deck, Side-to-side adjustment

MAINTENANCE

To level deck

Adjust the deck while the mower is on a level surface. Make sure the tires are inflated to the correct pressure. See “Technical Data” on page 64. If tires are under or over inflated, you can not properly adjust your deck.

NOTE: It may be easier to adjust the front lift linkages by removing the floor pan before any adjustments are made.

Side-to-side adjustment

1.Raise the deck into the highest cutting position 4 1/2" (114 mm)

2.Measure height from the bottom edge of the deck to the ground at both front corners. Distance “A” at both corners should be the same.

3.If adjustment is necessary, make adjustment to one side of the deck only.

4.To raise one side of the deck, using a 9/16" wrench, tighten the hex nuts on both the front and rear lift linkages (be sure to tighten equal amounts).

5.To lower one side of the deck, reverse previous step.

6.Recheck measurements after adjustment.

CZ-16

Distances A

1

2

CZ-17

1.Hex nut

2.Front lift linkage

Front adjustment

CZ-18

1.Hex nut

2.Front lift linkage

Rear adjustment

English-49