Connecting the Multi-Burner using configuration 2

To connect the Multi-Burner to your system, complete the following procedure. Refer to Figure 1-2during installation.

Figure 1-2. Configuration 2: USB standard bus power configuration

1.Turn on your computer.

2.

Using the USB cable

, insert the cable plug

into the USB connector of

 

the drive while squeezing the two buttons on the connector.

3.

Plug the standard USB connector

into the USB port of your computer.

4.

Using the USB cable

, insert the cable plug

into the DC IN connector of

 

the drive.

 

 

 

5.

Plug the standard USB connector

into the USB port of your computer.

Chapter 1. Multi-Burner quick install 1-5

Page 19
Image 19
IBM 22P9176 manual Configuration 2 USB standard bus power configuration