Installing a drive | IBM 2289, 6824 guide

Installing a drive

To install an internal drive, follow these steps:

1.Remove the cover. See “Removing the cover” on page 10.

2.If your computer has a CD-ROM drive or DVD-ROM drive, you might need to remove the signal and power cables from the drive.

3.Remove the bay panel from the drive bay by inserting a flat-blade screwdriver at the end and gently prying it loose.

4.Remove the metal shield from the drive bay by inserting a flat-blade screwdriver into one of the slots and gently prying it loose.

5.Make sure the drive that you are installing is set correctly as either a master or a slave device.

v If it is the first CD-ROM drive or DVD-ROM drive, set it as a master device.

vIf it is an additional CD-ROM drive or DVD-ROM drive, set it as a slave device.

vIf it is an additional hard disk drive, set it as a slave device.

Refer to the documentation that comes with your drive for master/slave jumper information.

Chapter 1. Installing options 17

Image 29

IBM 2289, 6824 manual Installing a drive

Contents

User Guide Type 2289 Page User Guide Type 2289 Page Appendix B. Manual modem Iv User Guide To connect To disconnect Safety Information Connexion Déconnexion Lithium battery noticeModem safety information Consignes de sécurité relatives au modem Laser compliance statement Viii User Guide Information resources Overview User Guide Features Installing options Audio subsystem Security features Specifications Handling static-sensitive devices Available optionsTools required Installing external options Locating the connectors on the front of your computer Locating the connectors on the rear of your computer Obtaining device drivers Connector Description Removing the cover Identifying parts on the system board Locating components Installing memory What to do next Installing adapters Installing internal drives Drive specifications Installing a drive Connecting the first IDE CD-ROM drive or DVD-ROM drive Physical security Connecting an additional IDE CD-ROM drive or DVD-ROM drive Changing the battery Replacing the cover and connecting the cables Erasing a lost or forgotten password clearing Cmos Installing options User Guide Starting the IBM Setup Utility program Using the IBM Setup Utility programViewing and changing settings Exiting from the IBM Setup Utility program Administrator password User passwordSetting, changing, and deleting a password Using Security Profile by Device Changing the startup device sequence Selecting a startup deviceSelecting a temporary startup device User Guide Updating flashing Bios from your operating system Updating flashing Bios from a disketteAppendix A. Updating System Programs System programs Recovering from a POST/BIOS update failure Basic AT commands Appendix B. Manual modem commands Extended AT commands Enable RTS/CTS hardware flow control Guard tone disabledUS setting for off-hook-to-on-hook ratio Force DSR Signal High on Fax Class 2 commands MNP/V.42/V.42bis/V.44 commandsFax Class 1 commands Voice commands User Guide System memory map Appendix C. System address mapsAddress map Address range Address range hex Size Description Decimal LPT3 Address hex Description Bits Byte pointer DMA I/O address map Address hex Description Bits Byte pointer DMA channel Data width System resource System resource User Guide Television output notice Appendix E. Notices IBM Trademarks DVD IndexPage Page Part Number 49P1040