Installing internal drives | IBM 2289, 6824 specification

4.Install the adapter into the appropriate slot on the system board.

5.Secure the adapter with the screw as shown.

What to do next

vTo work with another option, go to the appropriate section.

vTo complete the installation, go to “Replacing the cover and connecting the cables” on page 21.

Installing internal drives

This section provides information and instructions for installing and removing internal drives.

Internal drives are devices that your computer uses to read and store data. You can add drives to your computer to increase storage capacity and to enable your computer to read other types of media. Some of the different drives that are available for your computer are:

vHard disk drives

vCD-ROM drives or DVD-ROM drives

vRemovable media drives

Internal drives are installed in bays. In this book, the bays are referred to as bay 1, bay 2, and so on.

When you install an internal drive, it is important to note what type and size of drive that you can install in each bay. Also, it is important to correctly connect the internal drive cables to the installed drive.

Chapter 1. Installing options 15

Image 27

IBM 2289, 6824 manual Installing internal drives

Contents

User Guide Type 2289 Page User Guide Type 2289 Page Appendix B. Manual modem Iv User Guide To connect To disconnect Safety Information Lithium battery notice Modem safety informationConnexion Déconnexion Consignes de sécurité relatives au modem Laser compliance statement Viii User Guide Information resources Overview User Guide Features Installing options Audio subsystem Security features Specifications Available options Tools requiredHandling static-sensitive devices Installing external options Locating the connectors on the front of your computer Locating the connectors on the rear of your computer Obtaining device drivers Connector Description Removing the cover Identifying parts on the system board Locating components Installing memory What to do next Installing adapters Installing internal drives Drive specifications Installing a drive Connecting the first IDE CD-ROM drive or DVD-ROM drive Physical security Connecting an additional IDE CD-ROM drive or DVD-ROM drive Changing the battery Replacing the cover and connecting the cables Erasing a lost or forgotten password clearing Cmos Installing options User Guide Exiting from the IBM Setup Utility program Using the IBM Setup Utility programStarting the IBM Setup Utility program Viewing and changing settings Using Security Profile by Device User passwordAdministrator password Setting, changing, and deleting a password Selecting a startup device Selecting a temporary startup deviceChanging the startup device sequence User Guide System programs Updating flashing Bios from a disketteUpdating flashing Bios from your operating system Appendix A. Updating System Programs Recovering from a POST/BIOS update failure Basic AT commands Appendix B. Manual modem commands Extended AT commands Force DSR Signal High on Guard tone disabledEnable RTS/CTS hardware flow control US setting for off-hook-to-on-hook ratio MNP/V.42/V.42bis/V.44 commands Fax Class 1 commandsFax Class 2 commands Voice commands User Guide Address range Address range hex Size Description Decimal Appendix C. System address mapsSystem memory map Address map LPT3 Address hex Description Bits Byte pointer DMA I/O address map Address hex Description Bits Byte pointer DMA channel Data width System resource System resource User Guide Television output notice Appendix E. Notices IBM Trademarks DVD IndexPage Page Part Number 49P1040