Drive specifications | IBM 6824, 2289 specs

Drive specifications

Your computer comes with the following IBM-installed drives:

vA CD-ROM drive or DVD-ROM drive in bay 1

vA 3.5-inch diskette disk drive in bay 3

vA 3.5-inch hard drive in bay 4

Any bay that does not have a drive installed has a static shield and bay panel installed.

The following illustration shows the locations of the drive bays.

The following table describes some of the drives you can install in each bay and their height requirements.

1Bay 1 - Maximum height: 43.0 mm (1.7 in.)	CD-ROM drive or DVD-ROM drive
	(preinstalled in some models)
	5.25-inch hard disk drive
2Bay 2 - Maximum height: 43.0 mm (1.7 in.)	5.25-inch hard disk drive
	3.5-inch hard disk drive (requires a
	mounting bracket)
	CD-ROM drive
	DVD-ROM drive
3Bay 3 - Maximum height: 25.8 mm (1.0 in.)	3.5-inch diskette drive (preinstalled)
4Bay 4 - Maximum height: 25.8 mm (1.0 in.)	3.5-inch hard disk drive

Notes:

1.Drives that are greater than 43.0 mm (1.7 in.) high cannot be installed.

2.Install removable media (tape or CD) drives in the accessible bays (bay 1 or 2).

16User Guide

Image 28

IBM 6824, 2289 manual Drive specifications

Contents

User Guide Type 2289 Page User Guide Type 2289 Page Appendix B. Manual modem Iv User Guide Safety Information To connect To disconnect Modem safety information Lithium battery noticeConnexion Déconnexion Laser compliance statement Consignes de sécurité relatives au modem Viii User Guide Overview Information resources User Guide Installing options Features Audio subsystem Security features Specifications Tools required Available optionsHandling static-sensitive devices Installing external options Locating the connectors on the front of your computer Locating the connectors on the rear of your computer Connector Description Obtaining device drivers Removing the cover Locating components Identifying parts on the system board Installing memory What to do next Installing adapters Installing internal drives Drive specifications Installing a drive Connecting the first IDE CD-ROM drive or DVD-ROM drive Connecting an additional IDE CD-ROM drive or DVD-ROM drive Physical security Changing the battery Replacing the cover and connecting the cables Erasing a lost or forgotten password clearing Cmos Installing options User Guide Using the IBM Setup Utility program Starting the IBM Setup Utility programViewing and changing settings Exiting from the IBM Setup Utility program User password Administrator passwordSetting, changing, and deleting a password Using Security Profile by Device Selecting a temporary startup device Selecting a startup deviceChanging the startup device sequence User Guide Updating flashing Bios from a diskette Updating flashing Bios from your operating systemAppendix A. Updating System Programs System programs Recovering from a POST/BIOS update failure Appendix B. Manual modem commands Basic AT commands Extended AT commands Guard tone disabled Enable RTS/CTS hardware flow controlUS setting for off-hook-to-on-hook ratio Force DSR Signal High on Fax Class 1 commands MNP/V.42/V.42bis/V.44 commandsFax Class 2 commands Voice commands User Guide Appendix C. System address maps System memory mapAddress map Address range Address range hex Size Description Decimal LPT3 DMA I/O address map Address hex Description Bits Byte pointer Address hex Description Bits Byte pointer System resource DMA channel Data width System resource User Guide Appendix E. Notices Television output notice Trademarks IBM Index DVDPage Page Part Number 49P1040