6
Configuring your Monitor

Setup Diskette for Windows95 or Windows 98

This section must be
completed before
continuin
g
with the
Windows 95 or Windows 98
Auto Setup on Pa
g
e 10.
To use the Plu
g
and Pla
y
feature in Windows 95 or Windows 98, files should
be loaded from the IBM Flat Panel Monitor Installation diskette:
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctl
y
.
3. Turn on the monitor and then the s
y
stem unit. Allow the s
y
stem to boot
into Windows 95 or Windows 98.
Your computer’s Plu
g
and Pla
y
code ma
y
warn
y
ou that
y
our s
y
stem
hardware has chan
g
ed. This probabl
y
means that it has detected
y
our
new monitor for the first time.
4. Open the DISPLAY PROPERTIES window b
y
clickin
g
on START, SETTINGS,
CONTROL PANEL and then double clickin
g
on the DISPLAY icon.
On LCD monitors,
unlike CRTs, a faster
refresh rate does not
improve displa
y
qualit
y
.
IBM recommends usin
g
1024 x 768 at a refresh
rate of 60Hz.
5. Select the SETTINGS tab.

• In case of Windows 95:

6. -1. Select the Chan
g
e Displa
y
T
y
pe button.
2. Select the Chan
g
e Monitor T
y
pe button.

• In case of Windows 98:

6. -1. Select the ADVANCED BUTTON.
2. Select the MONITOR tab.
3. Open the UPGRADE DEVICE WIZARD windows b
y
clickin
g
on
Chan
g
e button and then select the NEXT button.
If the UPGRADE DEVICE WIZARD is open
g
o step 6-3. if not
continue to step 4.
4. Select the “Displa
y
a list of the known drivers for this device so that
I can choose a specific driver” and then select the NEXT button.
7. Insert the Setup diskette into drive A: and select the HAVE DISK button.
8. Select OK.
9. Choose IBM T540 monitor and select OK. The files will be copied from
the diskette to
y
our hard drive.
10. Close all open windows and remove the diskette.
11. Reboot the s
y
stem.
The s
y
stem will automaticall
y
select the maximum refresh rate and
correspondin
g
Color Matchin
g
Profiles.
T54A-E.book Page 6 Saturday, February 19, 2000 12:05 PM