9
DEUTSCH ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
Auto Setup for DOS
If the monitor is in standb
y
mode (STANDBY ON), it
ma
y
automaticall
y
turn off while
y
ou are waitin
g
for it to warm up.
If this happens, switch off the
monitor and switch it on a
g
ain
after a few seconds.
1. Turn on the monitor first; then the PC.
If the messa
g
e CHECK SIGNAL CABLE is displa
y
ed, or if nothin
g
is
displa
y
ed check:
•that the video interface cable is connected properl
y
.
•the correct video adapter card is installed.
•the correct supported displa
y
mode is selected for
y
our PC.
If
y
ou are usin
g
PC-DOS/
V, chan
g
e to U .S. mod e b
y
t
y
pin
g
‘CHEV US’ and pressin
g
ENTER at the command
prompt.
2. Wait approximatel
y
15 minutes, until the monitor warms up.
3. Insert the diskette labelled ‘IBM Flat Panel Monitor Installation Diskette
into the diskette drive.
You must use DOS when
y
ou run DOS Auto Setup.
4. Displa
y
the command prompt screen of the DOS full-screen displa
y
.
5. At the command prompt, t
y
pe ‘A:’ and press ENTER.
6. T
y
pe ‘TESTPATD’ and press ENTER.
7. Select from the screen the number for the color or text mode
y
ou want to
setup.
8. Select from the screen the number for the video mode
y
ou want to
setup.
You ma
y
repeat this process for as man
y
of the color and video modes
as
y
ou need.
The size and diversit
y
of
the dot pattern varies with
the screen resolution.
9. When the dot pattern appears, press the OSD Enter button at the
bottom of the monitor to displa
y
the initial OSD menu.
If the screen flickers,
repeat the setup several
times until the flicker is
minimised, or adjust it manuall
y
b
y
followin
g
Manual Setup on
pa
g
e 12.
10. Use an Arrow button ( or ) to select the IMAGE LOCK icon
then press the OSD Enter button to access the function.
11. Usin
g
an Arrow button ( or ), select AUTOMATIC and press the
OSD Enter button . This activates the AUTO SETUP procedure, which
will optimize the displa
y
settin
g
s with the provided dot-patterns.
The screen will3d off several times and
y
ou ma
y
notice small chan
g
es to
the test pattern.
12. When finished, the OSD main menu returns. Press the Exit button
to exit from the OSD.
13. Press the ESCAPE ke
y
to exit the test pattern pro
g
ram.
14. T
y
pe ‘Exit’ at the command prompt to return to Windows.
If
y
ou use other operatin
g
s
y
stems, perform the appropriate AUTO SETUP for
those s
y
stems, also: see

Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT or

Windows 2000 on pa

g

e 10.

T54A-E.book Page 9 Saturday, February 19, 2000 12:05 PM