21
ENGLISH
11. Press one of the contrast control buttons. The messages are
automatically displayed in the following sequence :
‘OFF-READY- START-COMPLETED’ and auto setup is complete.
If “AUTO SETUP COMPLETED” is not displayed, repeat the auto setup
procedure several times. If auto setup continues to fail, complete the
Manual Setup on page 28.
12. Press F3 to exit the color-bar pattern.
13. Type CLEAR at the AIX command prompt and press ENTER to perform
setup on black level.
14. Push one of the brightness control buttons and select the item
BLACK SETUP.
15. Push one of the contrast control buttons. After about 10 seconds,
the message ‘SAVE PARAMETERS?’ is displayed.
If 'BLACK SETUP FAILED’ is displayed - if the message ‘SAVE
PARAMETERS?’ is not displayed or BLACK SETUP does not start, do the
following :
• Confirm that the screen is completely black except for the command
prompt. If not, type ‘clear’ and press ENTER.
• Go back to step 15 and redo black setup.
If black setup is not completed after several tries, adjust OFFSET R, OFFSET G,
OFFSET B (see
Specialist Controls on page 33).
16. To save the settings for the monitor, push a contrast control button.
To discard the settings, push one of the brightness control button.
17. Press the Setup Switch on the back of the monitor to turn off the setup
main menu.
You have completed the monitor setup.
If the screen flickers, repeat
the setup several times until
the flicker is minimised, or adjust
it manually by following Manual
Setup on page 28.
txteng.book Page 21 Friday, April 3, 1998 3:28 PM