9
ENGLISH
Monitor Information Diskette for Windows 95
To utilise the Plug and Play feature in Windows 95, files should be loaded
from the IBM Color LCD Monitor Installation diskette as follows :
1. Turn off the computer and all attached devices.
2. Ensure that the IBM monitor that you wish to install is connected
correctly.
3. Power on the monitor and then the system unit. Allow the system to
boot into Windows 95.
4. Open the DISPLAY PROPERTIES window by clicking on START,
SETTINGS, CONTROL PANEL and then double clicking on the
DISPLAY icon.
5. Click on the SETTINGS tab.
6. Click the CHANGE DISPLAY TYPE button.
7. Click CHANGE MONITOR TYPE button.
8. Insert the Monitor Information diskette into drive A: and click the HAVE
DISK button.
9. Click ‘OK’.
10. Choose IBM 9516 monitor and click OK. The files will be copied from
the diskette.
11. Close all open windows and remove the diskette.
12. Reboot the system.
The system will automatically select the maximum refresh rate and
corresponding Colour Matching Profiles.
This section must be
completed before
continuing with the
Windows 95 Auto Setup on
page 12.
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends using
a refresh rate of 60Hz non-
interlaced.
txteng.book Page 9 Friday, April 3, 1998 3:28 PM