13
ENGLISH
Auto Setup OS/2
Continued from

Auto Setup for DOS

on page 11
11 If the WarpCenter Toolbar is permanently on, click the right mouse
button on the WarpCenter Toolbar, click on Properties, Display Tab and
‘Show only when mouse in center position’.
12. Insert the diskette labelled ‘ Setup Option Diskette (for OS/2)’ into the
diskette drive.
13. Open the OS/2 full-screen window or an OS/2 window.
14. At the command prompt type A: and press ENTER.
15. Type TESTPATS and press ENTER.
16. After approximately 1 minute, the color-bar pattern appears.
17. Move the mouse pointer (and the icon bar and tool bar if they are
displayed) to the bottom center of the screen to allow setup to run
properly.
18. The AUTO SETUP line changes to COMPLETED when auto setup is
completed after 10 to 20 seconds.
If “AUTO SETUP COMPLETED” is not displayed, or the “AUT O SETUP FAILED”
message appears, repeat the auto setup procedure several times. If auto setup
continues to fail, complete the
Manual Setup
on page 28.
19. Press ALT+F4 to exit auto setup.
You have completed the monitor setup.
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
The size and diversity of
the color pattern varies with
the screen resolution.
If the screen flickers,
repeat the setup several
times until the flicker is
minimised, or adjust it manually
by following Manual Setup on
page 28
.
txteng.book Page 13 Friday, April 3, 1998 3:28 PM