22
Auto Setup for the GXT150P (RS/6000 Model 40P) Adapter
1. Insert the ‘IBM RISC System/6000 Model 40P, System Management
Service Diskette’ into drive A of the RS/6000 Model 40P Adapter. Turn
on the power.
If the message UNSUPPORTED VIDEO is displayed, or if nothing is displayed
check:
• that the video interface cable is connected properly.
• the correct video adapter card is installed (see page 40)
• the correct supported display mode is selected for your PC.
2. When the Power Personal System panel is displayed, press F4. The
screen remains blue until the system is ready.
3. From the main menu of System Management Service, select ‘Test The
Computer’. Then press ENTER.
4. Wait for about 15 minutes, until the monitor warms up.
5. In the Select Device Test menu, push the spacebar to erase the mark
displayed with ‘Test All Subsystems’. Use the ↓ key to place the cursor
on GTP150P. Push the spacebar to select GXT150P. Then press F6.
6. Use the ↓ key to select ‘Run Monitor Service Aids’ in the IBM GXT150P
Video Adapter menu. Press ENTER.
7. When GXT150P Information is displayed, press ENTER.
8. When the color-bar pattern is displayed, push the setup switch on the
back of the monitor. The setup main menu appears on top of the color-
bar pattern.
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
txteng.book Page 22 Friday, April 3, 1998 3:28 PM