11
ENGLISH
Auto Setup for DOS1. Turn on the monitor first; then the PC.
If the message UNSUPPORTED VIDEO is displayed, or if nothing is displayed
check:
• that the video interface cable is connected properly.
• the correct video adapter card is installed (see
Video Adapters
on page
40).
• the correct supported display mode is selected for your PC.
2. Wait approximately 15 minutes, until the monitor warms up.
3. Insert the diskette labelled ‘ Setup Option Diskette (for DOS / Windows /
Windows NT)’ into the diskette drive.
4. Display the command prompt screen of the DOS full-screen display:
• If Windows is installed, open the DOS prompt from the Program
Manager to display the DOS full-screen.
• If OS/2 is installed, open the DOS full-screen display from the
command prompt of OS/2.
• If only DOS is installed, the command prompt is displayed when the
system is started.
5. At the command prompt, type ‘A:’ and press ENTER.
6. Type ‘TESTPATD’ and press ENTER. The color-bar pattern appears.
7. Wait until the PRESS [ENTER] KEY message is displayed.
8. Press ENTER to continue the auto setup procedure.
9. The AUTO SETUP line changes to COMPLETED when auto setup is
complete.
If “AUTO SETUP COMPLETED” is not displayed, or the “AUT O SETUP FAILED”
message appears, repeat the auto setup procedure several times. If auto setup
continues to fail, complete the manual setup on page 28.
10. Type ‘Exit’ at the command prompt to return to Windows.
Now continue the setup for your operating system:
Auto Setup for Windows 3.1, Windows 95, or Windows NT
on page 12
Auto Setup OS/2
on page 13
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
If you are using PC-DOS/V,
change to U.S. mode by
typing ‘CHEV US’ and pressing
ENTER at the command prompt.
If the screen flickers,
repeat the setup several
times until the flicker is
minimised, or adjust it manually
by following Manual Setup on
page 28.
txteng.book Page 11 Friday, April 3, 1998 3:28 PM