28
Manual Setup
Normally, you can complete the setup procedure using auto setup. However,
if your screen image is still distorted after you perform auto setup, perform
manual setup.
1. Wait for about 15 minutes, until the monitor warms up.
2. Display the image you most frequently use on the screen.
3. Push the setup switch on the back of the monitor.
4. Push one of the brightness control buttons and select the item
CLOCK in
Intermediate Controls
on page 32. Then push one of the
contrast control buttons to minimise the number of vertical lines on
the screen.
5. Push one of the brightness control buttons, and select the item H-
POSI to adjust the horizontal display position. Likewise, select the item
V-POSI to adjust the vertical display position.
6. Push one of the brightness control buttons and select the item
PHASE, and adjust the contrast to reduce the distortion on the screen.
7. Select SAVE. Then push one of the contrast control buttons to save
the settings. The color of the characters “SAVE” changes from red to
yellow, and back to red again.
8. Push the setup switch on the back of the monitor to exit the menu.
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off while
you are waiting for it to warm up.
txteng.book Page 28 Friday, April 3, 1998 3:28 PM