IBM manual Remote AS/400, AS/400 Prompt, Parameter

	AS/400	Remote AS/400
AS/400 Prompt	Parameter	Parameter	Notes
Connection initiation	CNNINIT	CNNINIT	If X.25 DCE support is specified (X25DCE(*YES)) for
			either system, CNNINIT(*LOCAL) should also be
			specified on that system’s line description. The other
			system (with X25DCE(*NO) specified) should specify
			CNNINIT(*REMOTE) or CNNINIT(*WAIT).
			For switched connections, both systems can also
			specify X25DCE(*NEG) to negotiate the Distributed
			Computing Environment (DCE) and data terminal
			equipment (DTE) roles and CNNINIT(*CALLER) to allow
			either system to initiate the connection by making the
			call.
			See the X25DCE parameter for additional
			considerations.
Duplex	DUPLEX	DUPLEX	Depending on the type of communications used, the
			values specified for the DUPLEX parameters may need
			to be coordinated.
Ethernet standard	ETHSTD	ETHSTD	Values specified for each system must be coordinated.
			Both systems must specify the same standard (*ETHV2
			or *IEEE8023) or at least one system must specify
			*ALL.
Exchange identifier	EXCHID	EXCHID	Remote AS/400 controller description EXCHID must
			match the local AS/400 line description EXCHID. The
			first three digits of the exchange identifier, known as the
			block number, is 056 for the AS/400 line. You can use
			the Work with Line Descriptions (WRKLIND) command
			to determine this value.
Logical channel	LGLCHLE	LGLCHLE	If X.25 DCE support is specified (X25DCE(*YES) or
entries			X25DCE(*NEG)), logical channel types and channel
			numbers must be coordinated. See also the
			considerations for the X25DCE parameter.
Line speed	LINESPEED	LINESPEED	For asynchronous lines, the line speeds specified for
			each system must match.
Modulus	MODULUS	MODULUS	If X.25 DCE support is specified (X25DCE(*YES) or
			X25DCE(*NEG)), modulus values specified for each
			system must match.
			The values specified for this parameter should match for
			all communications types.
Local network address	NETADR	CNNNBR	For switched virtual circuits (SVCs), the NETADR
			parameter on the local system line description must
			match the CNNNBR parameter on the controller
			description for the remote system.
NRZI data encoding	NRZI	NRZI	Values specified for each system must match (*YES or
			*NO).
Data link role	ROLE	ROLE	The value specified for the local system line description
			ROLE parameter should match the controller description
			ROLE parameter specified at the remote system.
Number of stop bits	STOPBITS	STOPBITS	Values specified for each system must match.
Switched connection	SWTCNN	SWTCNN	Values specified for each system must be compatible.
type			(*DIAL or *ANS must not be specified for both systems.)

34Version 5