IBM manual Matching AS/400 parameters for a 5494 connected by

Matching AS/400 parameters for a 5494 connected by X.21

You must coordinate communications configuration parameters between AS/400 and the 5494 remote controller that is connected by X.21. These parameters are described in the following table. Then the related fields and subfields from the 5494 configuration display are listed next. These values are followed by the AS/400 configuration value and the matching 5494 value to be entered in the display subfield. You can coordinate these values automatically or manually. Pick one of these ways:

vTo automatically connect the AS/400 to a 5494 controller, you can use the automatic remote controller (QAUTORMT) system value.

vTo manually connect the AS/400 to a 5494 controller:

–See “Example: Connecting AS/400 to a 5494 controller connected by X.21” on page 53 for an example of connecting AS/400 to a 5494 controller by X.21.

–Use the following table to configure the AS/400 to a 5494 controller by X.21.

For more information about configuring the 5494, see these books:

vIBM 5494 Remote Control Unit Planning Guide, GA27-3936

vIBM 5494 Remote Control Unit User’s Guide, GA27-3852,

AS/400	AS/400		5494
Prompt	Parameter	Field	Subfield	AS/400 Value	5494 Value	Notes
Connection	CNNNBR	15	-	-	-	Values specified for the AS/400
number
						CRTCTLAPPC command and
						for the 5494 Remote Control
						Unit must match. If the AS/400
						CRTCTLAPPC command
						specifies CNNNBR(*DC), the
						X.21 direct-call user facility
						must be used to make the
						connection.
Local	LCLLOCNAME	H1	1	-	-	Values specified for the AS/400
location						CRTCTLRWS command and
name						for the 5494 Remote Control
						Unit must match. This will
						probably match LCLLOCNAME
						in the network attributes. This
						value will probably match the
						LCLLOCNAME in the network
						attributes.
Remote	RMTCPNAME	13	-	-	-	Values specified for the AS/400
control						CRTCTLAPPC command and
point name						for the 5494 Remote Control
						Unit must match.
Remote	RMTNETID	11	3	-	-	Values specified for the AS/400
network						CRTCTLAPPC and
identifier						CRTCTLRWS commands and
						for the 5494 Remote Control
						Unit must match. This will
						probably match LCLNETID in
						the network attributes and H1:2.
Remote	RMTLOCNAME	12	-	-	-	Values specified for the AS/400
location						CRTCTLRWS command and
name						for the 5494 Remote Control
						Unit must match.

52Version 5