IBM AS/400 manual Version

	AS/400	Remote AS/400
AS/400 Prompt	Parameter	Parameter	Notes
Exchange identifier	EXCHID	EXCHID	If used, the local AS/400 controller description EXCHID
			must match the remote AS/400 line description
			EXCHID. The first three digits of the exchange identifier,
			known as the block number, is 056 for the AS/400 line.
			You can use the WRKLIND command to determine this
			value.
Initial connection	INLCNN	INLCNN	Values specified for each system must be coordinated;
			INLCNN(*ANS) must not be specified for both systems.
Link protocol	LINKPCL	LINKPCL	For X.25 connections, values specified for each system
			must match; both must be *QLLC or *ELLC.
Remote control point	RMTCPNAME	LCLCPNAME	RMTCPNAME specified on the local AS/400 system
name			controller description must match the local control point
			name specified in the network attributes of the remote
			AS/400 system.
Remote network	RMTNETID	LCLNETID	RMTNETID specified on the local AS/400 system
identifier			controller description must match the local network ID
			specified in the network attributes of the remote AS/400
			system.
Data link role	ROLE	ROLE	The value specified for the local AS/400 controller
			description ROLE parameter must match the remote
			AS/400 line description ROLE value.
X.25 reverse charging	RVSCRG	RVSCRG	Values specified for each system must be coordinated.
Switched network	SNBU	SNBU	Values specified for each system must match.
backup
Source service access	SSAP	DSAP	SSAP specified for the local AS/400 system must match
point			the DSAP specified in the remote AS/400 controller
			description.
Station address	STNADR	STNADR	Values specified for each system must match, unless
			both controller descriptions specify ROLE(*NEG).

Note: For asynchronous controllers (CRTCTLASC command), if the remote system controller description specifies RMTVFY(*YES), the local system controller description must specify a local identifier (LCLID parameter) and local location name (LCLLOCNAME parameter). The remote system must also create a configuration list with the LCLID and LCLLOCNAME values from the local system controller description.

For more information on AS/400 parameters, see the Communications Configuration book.

Matching AS/400 device description parameters for a remote AS/400 system

You must coordinate communications configuration parameters between local and remote AS/400 systems. The parameters are described in the following table. This table shows those prompts and parameters that must be coordinated when you specify device descriptions for the local and remote AS/400 systems.

To configure a local AS/400 to a remote AS/400:

vSee “Connecting one AS/400 to another AS/400 system” on page 37 for an example of connecting one AS/400 to another AS/400 system.

vUse the following table for the device description.

36Version 5