IBM AT-FS202SC/FS2, AT-FS202SC/FS4, AT-FS202SC/FS1, AT-FS201, AT-FS202SC/FS3 manual

Installing the Switch

Table 6 DIP Switch Settings (Continued)

DIP
Switch	Port	Setting	Position	Description
Number
3	2	Duplex	Up	The twisted-pair port is operating at
		Mode		half-duplex mode.
			Down	The twisted-pair port is operating at
				full-duplex mode.
4	2	Auto Neg	Up	Auto-Negotiation on the twisted-pair
				port is OFF.
			Down	Auto-Negotiation on the twisted-pair
				port is ON.

Caution

After you change the speed or duplex mode of the switch, you must power cycle (shut down and restart) the switch for the new settings to take affect.

4.Place the switch on a secure, level surface, leaving ample space around the switch for ventilation.

5.Plug the AC/DC power adapter into an appropriate AC power outlet and insert the power plug into the DC receptacle located on the back of the switch.

6.Verify that the PWR LED is green. If the LED is OFF, refer to “Troubleshooting” on page 19 for instructions.

7.Remove the dust cover from the fiber optic port and connect the fiber optic cable to the 100Base-FX port.

8.Connect the fiber optic cable to the 100Base-FX port on the end node.

9.Connect the twisted-pair cable (or cables) to the 10Base-T/100Base-TX port.

16