IBM M71V2 manual Imager Options 2D Imager Only, Laser Timeout, Read Verify, Trigger Mode

	The purpose of the laser aim is to be able to tell where the laser
	beam is pointing when scanning bar codes that are a long way
	away from the unit. The laser point helps to locate the beam before
	the laser starts rastering. Once the laser starts rastering, the bar
	code will be scanned.
Laser Timeout	Turns off Laser / CCD after (1 – 9) seconds when the trigger is
	pushed in Pulse mode, or held down in Trigger mode. The laser /
	CCD will always turn off immediately after a good read.
Read Verify	Performs bar code re-reads the number of times (0 – 9) required for
	applications where accuracy is critical. This is used where the bar
	code is poorly printed or damaged.

Imager Options (2D Imager Only)

These options are used to configure the 2D Imager device behavior, and the trigger mode for the M71V2 handheld terminal.

Trigger Mode

Trigger Trigger activates scanning device for as long as trigger is held up to the Laser Timeout value in seconds. (Recommended)

Pulse Continues to keep the scanner active even when the trigger is not held down, up to Laser Timeout value in seconds.

Laser Timeout Turns off Laser / CCD after (1 – 9) seconds when the trigger is pushed in Pulse mode, or held down in Trigger mode. The laser / CCD will always turn off immediately after a good read.

Aim Time (mS) The amount of time the green LED aiming beam is on.

The purpose of the LED aiming beam is to be able to locate where the center of the LED beam is pointing when scanning bar codes

106