IBM Nortel 10 manual Disconnecting a CX4 module cable, Connecting an XFP module cable

RS232

LINK

1

3

LINK

4

TX/RX

3.Check the LEDs on the GbE switch module. When the GbE switch module is operating correctly, the green link LED is lit. For information about the status of the switch module LEDs, see “LEDs” on page 6.

Disconnecting a CX4 module cable

To disconnect a CX4 cable, grasp the blue release tab on the cable connector and firmly pull it out of the module.

Connecting an XFP module cable

Attention: To avoid damage to the fiber-optic cables, follow these guidelines:

vDo not route the cable along a folding cable-management arm.

vWhen attaching the cable to a device on slide rails, leave enough slack in the cable so that it does not bend to a radius of less than 38 mm (1.5 in.) when the device is extended or become pinched when the device is retracted.

vRoute the cable away from places where it can be snagged by other devices in the rack.

vDo not overtighten the cable straps or bend the cables to a radius of less than 38 mm (1.5 in.).

vDo not put excess weight on the cable at the connection point. Make sure that the cable is well supported.

To connect the XFP module cable, complete the following steps:

Note: The illustrations in this document might differ slightly from your hardware.

22Nortel 10 Gigabit Uplink Ethernet Switch Module: Installation Guide