CHAPTER 5 COMMAND REFERENCE
User's Manual U13502EJ2V0UM00
50
5.2.2 Type
The [Type] command sets the mode of communication with the target and operating clock. Because the
communication mode and operating clock differ depending on the device used, refer to the manual for the device for
details. Execute the [Type] command by clicking [Type] on the [Setting] pull-down menu or by clicking the
button on the screen.
When this command is executed, the TYPE setting window below opens. After the parameter file has been loaded,
the default values for the information specific to the device is grayed out, and the appropriate default values for the
device are automatically set for the other items. To change a default value, change the contents of the corresponding
item and click the [OK] button. The setting will be changed.
The following describes each parameter in the figure above.
•Selecting the device type (DEVICE TYPE)
The device type is determined by the information in the parameter file.
•Selecting the internal ROM format for the target microcontroller (FLASH, EEPROM)
A ROM type cannot be selected for a microcontroller that does not have EEPROM in the parameter definition
information. If a ROM type can be selected, select either of the following ROM types:
•FLASH FLASH memory
•EEPROM EEPROM
When FLASH memory is used, the memory cannot be correctly written to unless it has been erased.
The erase command cannot be executed when an EERPOM is used.
•Entering the start address (START ADDRESS)
The start address is determined by the parameter definition information. It is automatically set in the Block and
Area modes.