IBM PG-FP3 - page 56

CHAPTER 5 COMMAND REFERENCE
User's Manual U13502EJ2V0UM00
56
5.2.6 Connection Port
The [Connection Port] command sets a port for communication with the PG-FP3. This command is used to change
the baud rate or communication port of the host when RS-232C is used.
Click [Connection Port] on the [Setting] pull-down menu to execute this command. When the command is
executed, the following dialog box opens, allowing you to set a communication port.
If the printer interface was selected when the PG-FP3 started, the communication port setting must be LPTx. A
box for setting a baud rate is displayed in the dialog box, but a setting in this box is ignored.
If a wrong port was specified when FLASHPRO3 started, the error dialog box below is displayed. If this dialog box
is displayed, check the communication setting, and correct as necessary.
When [Connection Port...] in the dialog box is clicked, a dialog box for port setting opens.