CHAPTER 8 ERROR MESSAGES AND REMEDIAL ACTIONS
User's Manual U13502EJ2V0UM00
90
Error No. Message Cause/action
Cause IIC communication errorER3D IIC READ error. (ACK)
Action Check the target microcontroller.
Cause The area set with TYPE setting does not exist.ER3E Illegal select AREA.
Action Check the area information in the TYPE settings.
Cause An abnormal condition was detected in the internal RAM of the PG-
FP3.
ER40 CPU RAM error.
Action The PG-FP3 may be damaged.
Cause An abnormal condition was detected in the expansion RAM of the
PG-FP3.
ER41 Expansion RAM error.
Action The PG-FP3 may be damaged.
Cause The POWER SELECT switch is VDD OUT but USER VDD is supplied.ER42 Illegal SW Target ON.
Action Do not supply power (VDD) from the target when the POWER
SELECT switch is VDD OUT.
Cause The POWER SELECT switch is USER VDD but USER VDD is not
supplied.
ER43 Illegal SW Target OFF.
Action Supply power (VDD) from the target when the POWER SELECT
switch is USER VDD.
Cause The target system is not connected.ER44 Target is closed.
Action Check the connection of the target system.
Cause The SCK pin does not go high.ER45 IIC SCLK is Low level.
Action Check the SCK pin of the target system.
Cause An excess VPP current was detected.ER50 VPP OUT CURRENT error.
Action Check the VPP pin of the target system.
Cause An excess VDD current was detected.ER51 VDD OUT CURRENT error.
Action Check the VDD pin of the target system.
Cause An excess VCC (+5 V) current was detected.ER52 VCC (+5V) CURRENT error.
Action The PG-FP3 may be damaged.
Cause An excess EPROM VPP current was detected.ER53 EPROM VPP CURRENT error.
Action Check the master PROM. Alternatively, Flashpro3 may be
damaged.
Cause The target system voltage is abnormal.ER54 User VDD error.
Action Check the voltage of the target system.
Cause The specified area is not blank.ER5B Blank check.. Failed AREA
Action Erase the specified area with the Erase command.
Cause The specified area cannot be erased.ER5C ROM Erase.. Failed AREA
Action The specified area may be damaged.
Cause A verify error was detected in the specified area.ER5D Verify error. AREA
Action Erase the area with the Erase command, and reexecute writing.
Cause Excessive erasing was detected in the specifi ed area.ER5E Device error. AREA
Action The microcontroller may be damaged.
Cause A pre-write error was detected in the specified area.ER5F Erase setting error. AREA
Action The microcontroller may be damaged.