16.Follow the instructions on the screen.
17.Restart the computer. As you configure your communication software, you will be prompted to select a modem.
18.Select Lucent Win Modem to complete the Lucent Win Modem device driver installation.
Installing the Ethernet and modem device drivers in Windows NT 4.0
To install the PCI Ethernet Controller driver and the Lucent Win Modem in Windows NT 4.0, do the following:
1.Start Windows.
2.Click the Network icon in the Control Panel.
3.Click Yes to install Windows NT networking. The Network Setup Wizard window opens.
4.Select Wired to the network (default) and click Next.
5.Click Select from list.
6.Click Have Disk.
7.In the Insert Disk window, type the location of the
8.Click OK.
9.Click Next.
10.Under Network Protocols, select TCP/IP Protocol (default) and click Next.
11.Click Next in the Network Service window to select all the services listed.
12.Click Next to install selected components.
13.On the Windows NT Setup Screen, enter C:\i386 and click Continue. The PCI Ethernet Controller device driver is installed.
14.In the TCP/IP Setup window, click Yes.
15.On the window that requests network bindings, click Next.
16.Click Next to install and initialize the network services.
Note: If you are disconnected from the network, the DHCP Client window opens and you need to click Yes.
17.When your computer name and your workgroup displays, click Next.
18.Click Finish to complete the installation.
19.Click Yes to restart the computer to finish installation of the PCI Ethernet Controller.
20.When the computer restarts, click Start→Run.
