IBM R31, R30 manual Beep Symptoms, Post, PC133 Sdram

Error	Message	Meanings	Comment
Code
0193	RF antenna had	RFID antenna	RFID model
	been removed	has been	only.
		removed, which
		was once
		installed.
0194	The computer is	The computer is	RFID model
	carried through	carried through	only.
	the security	the security gate
	gate	(portal gate).
0197	Invalid remote	The remote	System go into
	change	chnfiguration for	BIOS Setup
	requested	the security chip	automatically.
		has failed.
		Confirm the
		operation and try
		again.

Beep Symptoms

Event	Description	S1/S3	Beep
POST
Diagnostic	End Diagnostic	N/A	1 short beep
boot	boot
Post error		N/A	3 short beeps
Low battery		N/A	4 short beeps
warning beep
Critical	System POST	N/A	3 long beeps
Thermal
DRAM type	PC133 SDRAM	N/A	2 long beeps
error	only
Responses of	Success	N/A	2 long, 1 short, and
Boot Block			then 1 long beep
BIOS Flash
	BIOS file size	N/A	1 long, 1 short beep
	mismatch
	BIOS file	N/A	1 long, 2 short beeps
	reading error
	Floppy drive not	N/A	2 short beeps
	installed
Run Time /
Sleep state
BaySwap	Inhibit bay swap	Yes	Continuous 2 short, 1
alarm			long beeps .
AC		NO	1 short beep
attach/detach
Power Control	System enters /	N/A	1 short beep
Beep	resume from
	S1/S3/S4 state.
Volume control	Volume key	N/A	1 short beep
beep	Up/Down

MT 2656, 2657, 2676 43