IBM RS/6000 SP manual SP Switch function MAP, Error #, Message/condition, Description and action

SP Switch function (MAP 0620)

Table 1-7. SP Switch error conditions (continued)

Error #	Message/condition	Description and action
−3	Device status: Device has been	Description: Possible hardware problem.
(SPS)	removed from network because of a	Action: Go to ªStep 0620-004º on page 1-21.
	bad signature
	Link status: Not operational
−4	Device status: Device has been	Description: Switch network not wired as specified in switch
(SPS)	removed from network, faulty	topology or problem with connection between switch and
	Link status: Link has been removed	device.
		Note: You may get this error number for a jack which could
	from network or miswired, faulty	connect to a node, but instead has a wrap plug. In this case,
		this message is a warning only and can be ignored.
		Action:
		1. Check this connection against the actual hardware cabling.
		2. If the cabling does not match, correct the cabling
		problem, then go to step 5 below.
		3. Check the processor node's hostname and switch node
		number against the configuration using the command:
		splstdata -s pg
		SDRGetObjects DependentNode
		4. If this occurs on all nodes of a frame, check for a
		logical-to-physical frame number mismatch.
		5. If there is a mismatch, have the customer update the
		configuration, or you can correct the cabling, as appropriate.
		6. Go to ªStep 0620-004º on page 1-21.
	Send packet from local node failed	Description: Possible hardware problem.
−5		Action: Go to ªStep 0620-004º on page 1-21.
(SPS)
−6	Device status: Device has been	Description: AUTOJOIN was not selected for node during
(SPS)	removed from network, no	removal.
	AUTOJOIN	Action:
	Link status: Link has been removed	1. If there is an obvious problem, like node powered off or
	from network, no AUTOJOIN
		disconnected, fix that problem first. Then issue Eunfence
		for this processor node or dependent node.
		2. If problem was resolved, repeat ªStep 0620-001ºon
		page 1-17for next problem or go to ªStep 0620-043ºon
		page 1-36to verify fix.
		3. If problem was not resolved, go to ªStep 0620-004ºon
		page 1-21.
	Device status: Device has been	Description: Possible hardware problem.
−7	removed from network for not	Action: Go to ªStep 0620-004º on page 1-21.
(SPS)	responding
	Link status: Link has been removed
	from network, fenced

1-20RS/6000 SP: SP Switch Service Guide