To update the flash memory, do the following:
1. Obtain an appropriate diskette containing the update.
2. Insert the System Program Service diskette into drive
A, and turn on the computer with ac power or a fully
charged battery.
3. Select Update system programs from the menu.
Power Systems Checkout
To determine whether a power systems problem is due to
the AC Adapter or the battery, do the following:
1. Remove the battery.
2. Connect the AC Adapter and check that power is
supplied.
3. Disconnect the AC Adapter and install the charged
battery; then check that power is supplied by the
battery.
If the problem is due to the AC Adapter, go to “AC
Adapter Checkout”
If the problem is due to the battery, go to “Battery
Checkout” on page 30
If the problem is not due to the AC Adapter or the
battery, go to “Backup Battery Checkout
(Nonrechargeable)” on page 31
AC Adapter Checkout: Thischeckout is used only
when the computer fails under ac power.
If the problem occurs only when the AC Adapter is
used with a port replicator, replace the replicator.
If the power-on indicator does not turn on, check the
power cord of the AC Adapter for conductivity and
installation.
1. Unplug the AC Adapter cable from the computer and
measure the output voltage at the cable plug. See
the following figure:
a. If the voltage persists, go to the next step.
b. If the voltage is correct, make sure the
connection between the DC/DC card and the
system board is not loose.
Pin Voltage (V dc)
1+15.5 to +17.0
2 Ground
IBM ThinkPad 380XD, 385XD (2635) 29