GEM0650/0956/1256 Remote | R&R- Water Reservoir, Bin Control |
Water Reservoir:
1.Disconnect electrical power supply.
2.Shut off water supply to the ice maker.
3.Remove the front panel.
4.Disconnect water inlet tube from reservoir inlet fitting.
5.To remove float valve, push in “locking tabs” as shown and pull float up. Note: The plunger/seat is available separately as a part.
6.To remove reservoir, pull up and remove water sensor.
7.Disconnect water outlet tubes.
8.Remove mounting screws from reservoir bracket, and remove reservoir from ice maker.
9.Reverse to reassemble.
Float Assembly
Locking Tabs
Ice Chute
Slide Bin
Controls to
Remove
Water
Sensor
Bin Controls (Ice Level Sensors)
1.Disconnect electrical power supply.
2.Remove the front panel.
3.Remove the control box cover.
4.Locate ice chute, at the base of the chute, in front of and behind it are two plastic bin control mounts.
5.Slide each bin control to the left, and disconnect the electrical leads connecting the bin control to the circuit board.
6.Reverse to reassemble, be certain that the bin controls are aligned so that the ice level sensors are visible (centered) through the holes in the ice chute.
Page 33
