Fan Blade and Motor | Ice-O-Matic GEM1256R, GEM0956R, GEM0650R

GEM0650/0956/1256 Remote

R&R-Fan Blade and Motor

To Remove the Condenser Fan Motor Assembly:

1. Disconnect electrical power to the ice machine and/or remote condenser.

2. Remove fan guard.

3. Remove the fan blade.

4. Disconnect the electrical power lead to the fan motor.

5. Remove the four (4) bolts from the fan motor assembly.

6. Remove the fan motor assembly.

7. To Reassemble: Place the fan motor assembly on the condenser bracket and install the bolts. Wire the fan motor power leads, install the fan blade and replace the fan guard.

Fan Guard

Fan Blade

Fan Motor

Page 39

Image 45

Ice-O-Matic GEM1256R, GEM0956R, GEM0650R installation manual Fan Blade and Motor, To Remove the Condenser Fan Motor Assembly

Contents

By Ice-O-Matic Pearl Ice SeriesPage Keep this manual for future reference Introduction Table Of Contents Inspect Promptly Freight Claim ProcedureVisible Loss or Damage Concealed Loss or Damage Governing LAW Warranty For the Installer GEM0650/0956R GEM1256R Bin Application Ice Machine Specifications Storage Bin LocationIce machine Water Limitations Remote Condenser ERC Dimensions Inches GRC1001 GRC1061 GCR2061Pearl Ice Number Line Sets Remote Condenser Location Calculation FormulaCalculation Example Remote Condenser Location Roof AttachmentPrecharged Line Set Routing Typical Installation Final Connections Coupling Instructions Initial Connections For the Plumber Water InletDrains Ice Machine For the Electrician Completed Installation Final Check List Start Up There are no adjustments to make, so replace the panelsPre-Start Inspection Start Up Component Description Control Board GEM0650/0956/1256 Remote Electrical Sequence Water Operation WaterWater Level Water System Operation Refrigeration Refrigeration Schematic Low Condensing Temperature Pump Down Operation Performance Sanitizing and Cleaning Brush in direction of fins Condenser Maintenance Bearing Maintenance Bearing Maintenance Sensor Maintenance Bin Control SensorWater Sensor Auger Auger Maintenance Symptom Possible Cause Probable Correction Service Diagnosis Symptom High pressure cut out check Control System Diagnostics Water Reservoir, Bin Control Water ReservoirBin Controls Ice Level Sensors Bearing and Breaker To Remove the Breaker Bearing Assembly To Remove the Auger Auger To Remove the Water Seal Water SealRemoval of the Water Seal To Replace the Water Seal Replacing the Water Seal Evaporator To Replace the EvaporatorTo Reassemble the Evaporator and Auger Gear Motor To Remove and Repair the Gear Motor AssemblyTo Check the Gear Motor To Inspect the Gear Motor Fan Blade and Motor To Remove the Condenser Fan Motor Assembly Charging Procedure Refrigeration Service Wiring Diagram GEM0650R GEM0650R Wiring Diagram Wiring Diagram GEM0956R GEM0956R Wiring Diagram Wiring Diagram GEM1256R GEM1256R Wiring Diagram What to Do Before Calling for Service Service History