SPECIAL NOTES ON LCD MONITORS
The following symptoms are normal with LCD monitors and do not indicate a problem.
NOTE
nWhen you first turn on the LCD monitor, the picture may not fit in the display area because of the type of computer that is used. In this case, adjust the picture position to its correct position.
nDue to the nature of the backlight, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears.
nYou may find slightly uneven brightness on the screen depending on the desktop pattern you use.
nDue to the nature of the LCD screen, an afterimage of the previous screen may remain after switching the image, when the same image is displayed for hours. In this case, the screen is recovered slowly by changing the image or turning off the Power Switch for hours. There is the possibility that the previous screen has been fixed. Pay attention sufficient when you use LCD Monitor.
nContact your dealer or iiyama service center for the backlight replacement when the screen is dark, flickering or not lighting up. Never attempt to replace it by yourself.
ENGLISH
CUSTOMER SERVICE
NOTE n The fluorescent light used in the LCD monitor may have to be periodically replaced. For the warranty coverage on this component, please check with local iiyama service center.
n If you have to return your unit for service and the original packaging has been discarded, please contact your dealer or iiyama service center for advice or replacement packaging.
CLEANING
WARNING
CAUTION
NOTE
nIf you drop any materials or liquids such as water into the monitor when cleaning, unplug the power cable immediately and contact your dealer or iiyama service center.
nFor safety reasons, turn off the power switch and unplug the monitor before you clean it.
nTo protect the LCD panel, do not scratch or rub the screen with a hard object.
nNever use any of the following strong solvents. These will damage the cabinet and the LCD screen.
Thinner | |
Benzine | Wax |
Abrasive cleaner | Acid or Alkaline solvent |
nTouching the cabinet with any product made from rubber or plastic for a long time may cause degeneration or loss of paint on the cabinet.
CABINET Stains can be removed with a cloth lightly moistened with a mild detergent solvent. Then wipe the cabinet with a soft dry cloth.
LCD Periodic cleaning with a soft dry cloth is recommended.
SCREEN Don't use tissue paper etc. because these will damage the LCD screen.
2FOR YOUR SAFETY
