Indesit FM 37K IX DK Installation, Installing built-in ovens, Electric connection, Yellow-Green

Installation

Important: always unplug the appliance from the mains before making any adjustments or carrying out maintenance work.

Installing built-in ovens

To ensure the proper working order of the built-in appliance, the kitchen unit must be of a suitable size. The sizes of the unit for installing the cooker under a worktop or in a column unit are shown in figure.

		mm.		.min
				mm
	23			45			min
595mm.			mm.
				558	mm.	min	mm.593
		mm.	567
	5
595	mm.		.
			mm
			543
	.
	mm
	20

	.min
45	mm

mm.	23 mm.	558			585-575mm.	595mm.	.min
			mm.				mm
				min			45
595		mm.
	mm.	567
	5

595	mm.	.
		mm
		543
	.
	mm
	20

To ensure proper ventilation, the back panel of the unit must be removed. The cooker should be placed on two small wooden boards; should there be a one-piece worktop, there must be an opening of at least 45 x 600 mm.

.	45	mm.
mm
560

To secure the cooker to the unit, open the oven door and fix the cooker by screwing the 4 wooden screws into the 4 holes located in the outer frame.

The unit panels next to the cooker must be heat resistant. In the case of veneered wood units, glues must be resistant to a temperature of 100 °C. In accordance with safety standards, once the appliance has been mounted, there must be no possible contact with electrical parts. Any protective parts must be secured so that they can only be removed with the use of tools.

Electric connection

Cookers with a three-pole power supply cable are designed to operate with alternated current at the supply frequency and voltage indicated on the data plate (at the bottom of the oven dashboard). The earthing conductor of the cable is the yellow-green conductor.

V

Fig. A Fig. B

Feeding cable installation

Terminal block opening:

•Unscrew screw “V” (Fig. A).

•Pull and open the junction block lid.

For the installation of the feeding cable carry out the following operations Fig. B:

•unscrew the screw of the cable stop and the three screws of the contacts L-N-().

•Fix the small cables under the heads of the screws remembering to observe the colours: Blue (N) Brown

(L) Yellow-Green ().

•Fix the feeding cable in the special cable stop and close the cover.

Connecting the power supply cable to the mains The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains, suitable for the load indicated and complying with current directives (the earthing wire must not be interrupted by the circuit-breaker). The power supply cable must be positioned so that it does not exceed 50°C more than room temperature at any point of its length. Before making the connection check that:

10