DMC 1000 Digital Media Camcorder User’s Guide (v1.15) 29
Chapter 2 - Attaching parts
2.8 Wireless microphone receiver
To place a wireless microphone receiver into the camcorder, proceed as follows:
1. Switch off the camcorder.
2. Unscrew the two knurled screws that secure the wireless bay cover in place.
3. Tilt up the cover at the rear and slide backwards to remove it from the camcorder.
4. Remove the two plastic caps from the holes in the cover and store them in a safe place.
5. Ensure that the receiver unit is fitted with a 44-pin D-type connector (refer to the
manufacturer’s instructions).
6. Screw the antennas onto the receiver unit.
7. Pre-position the receiver unit’s four fixing screws and washers in the ducts.
8. Insert the wireless receiver unit into the bay with the text facing to the rear of the
camcorder. Push firmly until it is in place.
9. Secure the receiver unit to the camcorder chassis with the four fixing screws.
10. Switch on the camcorder and set up the receiver according to the manufacturer’s
instructions.
11. Slide the cover down over the antennas.
12. Insert the cover clip in under the carrying handle before pushing it all the way down into
its recess.
13. Tighten the two knurled screws to secure the cover in place.
Plastic caps
Knurled screws Ducts