Infinity DMC 1000 6.3 Recording audio

82 DMC 1000 Digital Media Camcorder User’s Guide (v1.15)
Chapter 6 - Audio setup
6.3 Recording audio
6.3.1 Select source
To select the source for each of the four recording channels:
1. Go to the AUDIO/CHANNELS menu.
2. Tap one of the SOURCE CH buttons numbered 1 to 4.
3. Tap the arrows in the pop-up box to select a source for that channel.
The sources are:
• Rear1 - analog audio 1 input,
• Rear2 - analog audio 2 input,
• Wrx1 - wireless channel (optional),
• Front1 - front microphone or stereo front microphone channel 1 (optional),
• Front2 - stereo front microphone channel 2 (only available when installed)
• MicRear - rear mini-jack headset microphone,
• AES1 - digital audio input channel 1 via BNC connector,
• AES2 - digital audio input channel 2 via BNC connector,
• SDI In1..8 - embedded digital audio input channels from the SDI input, or
• Mute.
Four channels are always recorded. When a recording channel is not used, set the recording
source for that channel to Mute.
6.3.2 Set recording levels
Audio levels for the four recording channels are controlled automatically or manually. When
manual control is selected, the two rotary controls at the left-rear of the camcorder are used to
adjust the audio levels. These can be programmed to adjust a single channel or a combination
of channels (1+3, 2+4).
The front audio level control can be assigned to any channel. This control can be used together
with the rotary controls at the rear.
Level 1
Level 2
SelectRec
Audio Level
Exp.
Time White Bal.
Level 1 control
Level 2 control
Front audio level control