Ingersoll-Rand FA5T manual Emergency Stop and Overload System, Emergency Stop optional feature

Pendant Hose and Operating Levers (old style) Emergency Stop Operation

(Dwg. MHP1311)

*For distances greater than 50 feet (15 metres) contact Ingersoll Rand Technical Sales for control suitability.

Remote Pilot Lever Throttle (optional feature)

Refer to Dwg. MHP0167 on page 56, item 358.

Provides for remote winch control at distances of up to 50* feet (15 metres) away from winch. The lever pilot control throttle is a fixed mount lever control station for winch operation. Pilot pressure from lever pilot control throttle activates winch control valve. The winch control valve, located on winch motor, controls motor speed and direction of drum rotation. Direction of rotation is determined by direction in which lever is shifted.

*For distances greater than 50 feet (15 metres) contact Ingersoll Rand Technical Sales for control suitability.

Emergency Stop and Overload System

Refer to Dwg. MHP2180 on page 52.

Air supply line is connected to air control valve. When emergency stop or overload valve is activated, all winch movement will stop.

CAUTION

•If winch continues to move (payout load) after emergency stop activates, brake(s) are not holding load and may require adjustment or repair.

When control valve senses a preset pressure difference between ports, a pilot signal is sent to stop flow of air, all winch movement will stop.

Emergency Stop (optional feature)

Refer to Dwg. MHP2047on page 15.

Emergency stop device is located on the control valve. When activated, winch drum rotation will immediately cease. To activate emergency stop, conduct the following:

1.Depress (push down) red palm valve, located on top of control valve.

(Dwg. MHP2047)

NOTICE

•If winch overload occurs, overload device, if equipped, also stops winch. To operate winch after an overload, reduce load and reset overload.

•Cannot be added to old style control valve. Refer to

Dwg. MHP2036 on page 50.

Emergency Stop Reset

Refer to Dwg. MHP2048 on page 15.

1.Rotate red stop button, in counterclockwise direction until red stop button ‘pops’ up.

2.Winch is ready to resume operation.

Emergency Stop Reset

(Dwg. MHP2048)

MHD56037 - Edition 5 15