Ingersoll-Rand FA5T manual Limit Switch optional feature, To Disengage

pull rod and ensure locking pin engages and is seated in drum hole and gland deep groove.

WARNING

•Ensure that all braking mechanisms are engaged and all personnel are clear of winch load and rigging before disengaging locking pin.

•Extremely difficult locking pin release is an indication that load is held by locking pin and braking mechanisms are not functioning properly. Do not release locking pin until load control is established.

To Disengage:

1.Pull out, straight away from outboard upright, pull rod (140) and rotate clockwise 90°. Align pin (135) with the shallow groove in gland (138) and release pull rod. Ensure locking pin (136) is clear of the drum (80) flange and pin is seated in gland shallow groove.

Limit Switch (optional feature)

Pre-set limit switch settings prevent winch wire rope payout and haul-in by stopping air flow to the winch motor when a defined set point has been reached. It is the owner’s and operator’s responsibility to adjust winch operating limits prior to using winch.

To adjust set points refer to ‘Adjustments’ in “MAINTENANCE” section.

WARNING

•Ensure limit switch set points are established and operating properly before using winch.

18 MHD56037 - Edition 5