Inova OnTimeTM owner manual Troubleshooting OnTime Digital Clock

Inova OnTime Digital Clock Owner's Manual

Section 8: Troubleshooting

The following table contains several trouble conditions you may encounter with the OnTime Digital Clock and the recommended actions to take to correct the problem.

Note: The up-to-date troubleshooting help is available in the FAQ at www.buyinova.com under the support tab.

Condition		Solution
Clock Face Dark	1.	Verify that an Ethernet PoE power injector is present (if required)
		and is operating.
	2.	Reboot the clock by disconnecting the data cable, counting to five,
		and reconnecting the cable.
Clock Shows Incorrect Time	1.	If the Service Light is illuminated (see below).
	2.	If the minutes past the hour are correct, verify the Time Zone and
		Daylight Saving Time settings.
DHCP Message on Clock Face	1.	The clock has failed to receive an IP address from the DHCP server.
	2.	Contact your IT group responsible for DHCP service.
	Note: that the clock is reachable through its fixed link-local address
	for diagnostic or re-configuration purposes. The link-local address is
	169.254.0.100
Service Light Blinking	The service light is located at the bottom right of the clock face.
	1.	There is an active telnet configuration session in progress on the
		clock.
Service Light On	The service light is located at the bottom right of the clock face.
	1.	Reboot the clock to verify that it properly receives a DHCP address.
	2.	Verify that the SNTP server configuration is valid as the service light
		will also be illuminated after several missed updates. Refer to the
		“Testing the Time Server Synchronization” section in Section 7: Telnet
		Configurations
Determine the IP Address of a	If the IP Address of each clock has not been recorded during installation,
Clock	it is suggested to follow this power cycle procedure.
	1.	Lift UP gently on the unit to free the keyholes at the rear of the clock
		from the mounting hardware.
	2.	Disconnect the network cable from the clock in question and count to
		five.
	3.	Replace the network cable and watch the face of the Inova Digital
		Clock.
	It will display its IP address as it boots.
Clock showing ------	No Time Server/Time Server down
Other Problems	Refer to the FAQ at www.buyinova.com under the support tab.

Table 6: Troubleshooting OnTime Digital Clock

All claims based on information publicly available at time of printing. All other product or service names mentioned in this document may be

trademarks of the companies with which they are associated. © 2007 Inova Solutions. All rights reserved. 6.12.2007 page 19