Insignia NS-HTIB51A 5.1 Channel Home Theater System

Wall mounting your speakers

To install the batteries:

The speakers can easily be wall mounted by using

1 Remove the cover.

 

the keyhole slots.

 

 

To mount the front or surround speakers vertically,

 

use the keyhole slot shown to hang each speaker

 

on a screw that is securely screwed into the wall.

 

Front speakers

Keyhole slot for wall

 

mounting

 

 

 

Batteries (AA/R6)

Surround speakers

Keyhole slot for wall

mounting

Keyhole slot for wall mounting

Center speaker

8-11/16” (240 mm)

To mount the center speaker horizontally, use the two keyhole slots shown to hang each speaker on two screws that are securely screwed into the wall.

Cautions

•A mounting screw’s ability to support a speaker depends on how well it’s anchored to the wall. If you have hollow walls, screw each mounting screw into a stud. If there are no studs, or the walls are solid, use suitable wall anchors.

•Use screws with a head diameter of 5/16" (9 mm) or less and a shank diameter of 1/8"

(4 mm) or less. With hollow walls, use a cable/pipe detector to check for any power cables or water pipes before making any holes.

•Leave a gap of between 3/16" (5 mm) and 7/16" (10 mm) between the wall and the base of the screw head. (We recommend that you consult a home installation professional.)

2Insert two AA batteries into the compartment matching the polarity indicated.

3Replace the cover.

Using the remote control

Use the remote control by pointing it towards the receiver’s remote sensor window. Objects between the remote control and sensor window may prevent proper operation.

Remote control sensor

Receiver

Approx. 16 ft. (5 m)

Use the remote control within about 16 feet

(5 meters) of the receiver and within 30 degrees of perpendicular to the front of the receiver.

Cautions

•Do not expose the remote control to shock. In addition, do not expose the remote control to liquids, and do not place in an area with high humidity.

•Do not place the remote control under direct sunlight. The heat may cause deformation of the remote control.

•The remote control may not work properly if the remote sensor window of the receiver is under direct sunlight or strong lighting. In such a case, change the angle of the lighting or receiver, or operate the remote control closer to the remote sensor window.

Installing batteries in the remote control

Cautions

•If the remote control doesn’t work reliably, try replacing the batteries.

•Don’t mix new and old batteries or different types of batteries.

•If you intend not to use the remote control for a long time, remove the batteries to prevent damage from leakage or corrosion.

•Remove expired batteries as soon as possible to prevent damage from leakage or corrosion.

Using the Audyssey 2EQ® room correction and speaker setup

With the supplied calibration microphone, Audyssey 2EQ automatically determines the number of speakers connected, their size (for purposes of bass management), optimum crossover frequencies to the subwoofer (if present), and distances from the primary listening position.

Audyssey 2EQ then removes the distortion caused by room acoustics by capturing room acoustical problems over the listening area in both the frequency and time domain. The result is clear, well-balanced sound for everyone.

Enabling Audyssey 2EQ lets you also use Audyssey Dynamic EQ®, which maintains the proper octave-to-octave balance at any volume level.

12

www.insigniaproducts.com