Insignia NS-HTIB51A 5.1 Channel Home Theater System

Error Messages

While the room correction and speaker setup is in progress, one of the following error messages may appear:

•Retry–Try again.

•Cancel–Cancel the room correction and speaker setup.

•Ambient noise is too high–The background noise is too loud. Remove the source of the noise and try again.

•Speaker Matching Error!–The number of speakers detected was different from that of the first measurement. Check the speaker connection.

•Writing Error!–This message appears if saving fails. Try saving again. If this message appears after two or three attempts, contact your Insignia dealer.

Understanding basic operations

Notes

•The on-screen setup menus appear only on a TV that is connected to the HDMI OUT jack. If your TV is connected to the MONITOR OUT V or the COMPONENT VIDEO OUT jacks, use the receiver’s display when changing settings.

•This manual describes the procedure using the remote control unless otherwise specified.

Playing a connected component

To play a connected component:

1Press RECEIVER, then press INPUT SELECTOR buttons to select the input source.

2Start playback on the source component.

3To adjust the volume, use the MASTER VOLUME control.

•Speaker Detect Error–This message appears if a speaker is not detected. No means that no speaker was detected.

Changing the speaker settings manually

You can manually make changes to the settings found during the room correction and speaker setup.

See also:

•“Configuring speakers (Sp Config menu)” on page 20.

•“Setting speaker distance (Sp Distance menu)” on page 20.

•“Setting the level calibration (Level Cal menu)” on page 21.

Using the powered subwoofer

The powered subwoofer outputs very low-frequency sound at a low volume level, therefore it may not be detected by Audyssey 2EQ Room Correction and Speaker Setup.

If Subwoofer appears on the Review Speaker Configuration screen as No, increase the

subwoofer’s volume to the half-way point, set it to its highest crossover frequency, and then try running Audyssey 2EQ Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, detection issues may occur, so use an appropriate volume level. If the subwoofer has a low-pass filter switch, set it to Off or Direct.

Operating your receiver

Turning your receiver on and off

To turn your receiver on and off:

1Press ON/STANDBY on the front panel.

- OR -

Press RECEIVER, then ON/STANDBY on the remote control.

The receiver turns on, the display lights, and the STANDBY indicator turns off.

2Press ON/STANDBY on the remote control again. The receiver enters standby mode.

To prevent any loud surprises when you turn on the receiver, always turn down the volume before you turn it off.

4Select a listening mode and enjoy!

See also “Using the listening modes” on page 16.

Displaying source information

To display source information:

•Press RECEIVER, then press DISPLAY repeatedly to cycle through the available information.

The following information can typically be displayed:

Input source and volume

Signal format or sampling frequency

Input source and listening mode

Notes

•When AM or FM radio is used, the band, preset number, and frequency are displayed.

•If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format is displayed. Information is displayed for about three seconds, then the previously displayed information reappears.

•The input source is displayed with the default name even when you have selected a name. See “Naming inputs (Name Edit menu)” on page 22.

Using the music optimizer

The music optimizer enhances the sound quality of compressed music files.

To use the music optimizer:

1Press AUDIO, then press or to select M.Optimizer.

2 Press or to select On.

14

www.insigniaproducts.com