Insignia
Connecting speakers | Connecting headphones |
Front right | Front left | Center |
Surround Surround
right left
Caution
Use speakers with an impedance of 6 Ω or more.
Caution
Do not let the bare speaker wires touch each other or any metal part of this receiver. Doing so may damage the receiver or speaker.
Note
Before connecting the speakers, refer to “Locating your speakers” on page 5.
To connect your speakers:
To connect your headphones:
•Insert the headphone plug into the headphone jack on the receiver.
Notes
•To hear sound from the headphones, make sure the SPEAKER button is set to off.
•When listening to a DTS or Dolby Digital program source, if the headphones are plugged in and the SPEAKER button is set to off, the receiver enters the 2CH downmix mode automatically. For more information, see “2CH downmix mode” on page 13.
•When EXTERNAL IN is selected as an input source, only the front left and front right channel signals can be reproduced through the headphones.
Connecting the power
To connect your receiver to power:
•Plug the power cord into an AC outlet.
Installing batteries
•Connect your speaker cables to the receiver.
Be sure to connect the speakers firmly and correctly according to the channel (left and right) and the polarity (+ and
If the sound is unnatural and lacks bass, the speaker polarity is incorrect.
After installing the speakers, adjust the speaker settings according to your environment and speaker layout. For more information, see “Modifying the speaker settings” on page 19.
Caution
Do not use
To install the batteries:
1Remove the cover.
8 |