|
|
|
|
|
|
| Insignia |
Adjusting each channel level with test tone | 2 Press the select or buttons to select the | ||||||
| The volume level of each channel can be | channel. | |||||
| The corresponding channel is selected as | ||||||
| adjusted easily with the test tone function. | ||||||
|
|
|
|
|
|
| follows: |
Note
When the SPEAKER button is set to off, the test tone function does not work.
To adjust each channel level:
1Press the TEST button.
The test tone mode is displayed and is heard from each channel’s speaker for two seconds as follows:
•
•
•
•
•
•
Note
When the speaker setting is “N (None or No)”, the test tone of the corresponding channel is not available.
2At each channel, press the select or buttons to adjust the level as desired until the sound level of each speaker sounds equally loud.
3Press TEST to cancel the test tone function.
Adjusting the current channel level
After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.
You can adjust the current channel levels as desired. These adjusted levels are memorized into user’s memory (CAL), not into preset memory (REF 1 and REF 2).
To adjust the current channel level:
1Press the CHANNEL LEVEL button.
OR
The memory mode (CAL) is displayed for several seconds. Wen the memory mode or channel level disappears, you can press this button again.
•REF 1, 2 (or CAL)
•FL
•C
•FR
•SR
•SL
•SW
•DTS or
Note
•Depending on the speaker settings (“N (None or No)”) and surround mode, some channels cannot be selected.
•When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected.
•The LFE level (DD and DTS) is applied after exiting the menu.
3Press the select or button to adjust the level of the channel.
The LFE level can be adjusted within the range of
In general, we recommend the LFE level to be adjusted to 0 dB.(However, the recommended LFE level for some early DTS software is
4Repeat this procedure to adjust each channel level.
Memorizing the adjusted channel levels
You can memorize the adjusted channel levels into preset memory (REF 1 or REF 2) and recall the memorized levels whenever you want.
To memorize the adjusted channel levels:
1After completing the steps under “Adjusting the current channel level” on page 14, press the MEMORY/ENTER button.
OR
The 1 of the REF 1 indicator flickers for several seconds.
2Press the select or buttons to select REF 1 or REF 2.
If the preset memory disappears, repeat step 1 above.
3Press the MEMORY/ENTER button to confirm your selection. The adjusted channel levels have now been memorized into the selected memory.
14 |