Insignia
Category | Problem | Possible Solution | ||
|
|
|
|
|
Poor FM | 1 | No antenna is | 1 | Connect an |
reception |
| connected. |
| antenna. |
| 2 The antenna is not | 2 | Change the position | |
|
| positioned for the |
| of the antenna. |
|
| best reception. |
|
|
|
|
|
| |
Continuous | Weak signals. | 1 | Change the position | |
hissing |
|
|
| of the antenna. |
noise during |
|
| 2 | Install an outdoor |
FM |
|
|
| FM antenna. |
reception, |
|
|
|
|
especially |
|
|
|
|
when a |
|
|
|
|
stereo |
|
|
|
|
broadcast is |
|
|
|
|
received. |
|
|
|
|
|
|
|
| |
Continuous | Noise is caused by | 1 | Keep the receiver | |
or | motors, fluorescent |
| away from noise | |
intermittent | lamps, or lightning. |
| sources. | |
hissing |
|
| 2 | Install an outdoor |
noise during |
|
|
| AM antenna. |
AM |
|
|
|
|
reception, |
|
|
|
|
especially at |
|
|
|
|
night. |
|
|
|
|
|
|
|
|
|
Remote | 1 | Batteries are not | 1 | Replace the |
control unit |
| loaded or are |
| batteries. |
does not |
| exhausted. | 2 | Remove the |
operate. | 2 | The remote sensor |
| obstacle. |
|
| is obstructed. |
|
|
|
|
|
|
|
Specifications
|
| Note | |
|
| • Design and specifications are subject to | |
|
| change without notice. | |
|
| • Weight and dimensions shown are | |
|
| approximate. | |
|
| • Specifications and external appearance may | |
|
| be changed for the sake of improvement. | |
|
|
| |
|
| ||
Amplifier | Power output, stereo mode, 6 Ω, THD 0.7%, | ||
| 40 Hz~20 kHz: 2×100 W | ||
|
| ||
| Total harmonic distortion, 6 Ω, 100 W, 1 kHz: 0.09% | ||
|
| ||
| Intermodulation distortion, 60 Hz, 7 kHz= 4:1 SMPTE, | ||
| 6Ω, 100 W: 0.1 % | ||
|
| ||
| Input sensitivity, 47 kΩ, Line (CD, TAPE, VIDEO): | ||
| 280 mV | ||
|
| ||
| Signal to noise ratio, IHF “A” weighted, Line (CD, TAPE, | ||
| VIDEO): 92 dB | ||
|
| ||
| Frequency response Line (CD, TAPE, VIDEO), | ||
| 20 Hz~50 kHz: +0 dB, | ||
|
| ||
| Output level | ||
|
| TAPE REC, 2.2 kΩ: 280 mV | |
|
| PRE OUT (Subwoofer), 1 kΩ:1.0 V | |
|
| ||
| Bass/Treble control, 100 Hz/10 kHz: ±10 dB | ||
|
| ||
| Surround mode, only channel driven | ||
|
| Front power output, 6Ω, 1 kHz, THD 0.7%: 125 W / | |
|
| 125 W | |
|
| Center power output, 6Ω, 1 kHz, THD 0.7%: 125 W | |
|
| Surround power output, 6Ω, 1 kHz, THD 0.7%: | |
|
| 125 W / 125 W | |
|
| ||
Digital | Sampling frequency: 32, 44.1, 48, 96 kHz | ||
Audio |
|
| |
Digital input level | |||
| |||
|
| Coaxial, 75Ω: 0.5 | |
|
| Optical, 660 nm: | |
|
|
|
Video | Video format: NTSC |
| Input sensitivity (=Output level), 75Ω |
| Video (Composite (normal)): 1 |
| |
| (chrominance signal): 0.286 |
| Component video |
| |
| (Y signal): 1.0 |
FM Tuner Tuning frequency range: 87.5~108 MHz
| Usable sensitivity, THD 3%, S/N 30 dB: 12.8 dBf | |
| 46 dB quieting sensitivity, mono/stereo: 20.2 / 45.3 dBf | |
|
| |
| Signal to noise ratio, 65 dBf, mono/stereo: 55 / 50 dB | |
|
| |
| Total harmonic distortion, 65 dBf,1 kHz, mono/stereo: | |
| 0.5 / 1.0% | |
|
| |
| Frequency response, 30 Hz~12 kHz: ±3.0 dB | |
|
| |
| Stereo separation, 1 kHz: 30 dB | |
|
| |
| Capture ratio: 4 dB | |
|
| |
| IF rejection ratio: 80 dB | |
|
| |
AM | Tuning frequency range: 520~1710 kHz | |
Tuner |
| |
Usable sensitivity: 500 µV/m | ||
| ||
|
| |
| Signal to noise ratio: 40 dB | |
|
| |
| Selectivity: 25 dB | |
|
| |
General | Power supply: 120 V ~ 60 Hz | |
|
| |
| Power consumption: 3.8 A | |
|
| |
| Dimensions (W×H×D, including protruding parts): | |
| ||
|
| |
| Weight (Net): 20.5 lbs (9.3 kg) |
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced technician for help.
FCC warning
Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user’s authority to operate this equipment.
Canada
This Class B digital apparatus complies with Canadian
21 |