Insignia
Recalling the memorized channel levels | 2 Press the TUNING / buttons repeatedly | |
To recall the memorized channel levels: | until the right frequency has been reached. | |
| ||
1 Press the CHANNEL LEVEL button. CAL or | TUNING | |
| REF 1 is displayed for several seconds. | |
|
| |
|
|
|
| Note |
|
| If the channel level mode display disappears, |
|
| press this button again. |
|
|
|
|
2Press the select 
or 
button to select REF 1 or REF 2. The channel levels memorized into the selected preset memory are recalled.
Listening to radio broadcasts
Auto tuning
To auto tune a radio station:
1Press FM/AM to select the band.
Auto presetting
The Auto Presetting function automatically searches for FM stations only and stores them in the memory.
To auto preset a radio station:
1While listening to a radio station, press and hold the MEMORY/ENTER button for more than two seconds.
The AUTO MEM flickers and the receiver starts auto presetting.
OR | Notes |
• Up to 30 FM stations can be stored. | |
| • Weak FM stations cannot be stored. To store |
| weak stations or AM stations, perform “Manual |
| presetting” on page 15 along with using |
|
Each time this button is pressed, the band changes as follows:
•FM ST
•FM MONO
•AM
When FM stereo broadcasts are poor because of weak broadcast signals, select the FM mono mode to reduce the noise. FM broadcasts are then reproduced in monaural sound.
2Press and hold the TUNING 
/
buttons for more than 0.5 seconds.
The tuner searches until a station of sufficient strength has been found. The display shows the tuned frequency and TUNED.
If the station found is not the station you want to listen to, repeat this procedure.
Weak stations are skipped during auto tuning.
Manual tuning
Manual tuning is useful when you already know the frequency of the station you want to listen to.
To manually tune a radio station:
1Press FM/AM to select the band.
Each time this button is pressed, the band changes as follows:
•FM ST
•FM MONO
•AM
When FM stereo broadcasts are poor because of weak broadcast signals, select the FM mono mode to reduce the noise. FM broadcasts are then reproduced in monaural sound.
Manual presetting
To manually preset a radio station:
1Tune to the station with auto or manual tuning.
2Press the MEMORY/ENTER button. MEM flickers for several seconds.
3Select a preset number between 1 and 30, then press the MEMORY/ENTER button again.
Notes
•When using the numeric keypad on the remote control, press the number you want. If your number is greater than nine, enter the first digit, then enter the second digit within two seconds.
•The station has been stored in memory. When using the numeric keypad, the station is stored automatically without pressing the MEMORY/ENTER button.
•A stored frequency is erased from memory by storing another frequency in its place.
•If MEM goes off, start again from step 2.
4Repeat this procedure to memorize additional stations.
Tuning to preset stations
To tune to a preset station:
1Select the tuner as the input source.
2Press the PRESET 
/
buttons on the receiver.
Enter the preset number using the numeric keypad.
Notes
When using the numeric keypad on the remote control, press the number you want. If your number is greater than nine, enter the first digit, then enter the second digit within two seconds.
15 |