Congratulations on your purchase of this quality InSinkErator® water product. In addition
to complete operating and care instructions, in this Owner’s Manual you will find instructions for installing both:
•
•
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
■IMPORTANT: After unpacking chilled water tank, place the unit upright for 1 hour before connecting power.
■For best results, the cold water faucet should be installed prior to installing the chilled water tank.
■For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or using this chilled water tank.
■This particular unit is not intended for commercial use.
■Make sure that all electrical wiring and connections conform to local codes.
■A standard
■It is recommended that a separate circuit providing power only to the chilled water tank be used.
■The wall outlet powering the chilled water tank must be fused and should not be controlled by the same wall switch used by the food waste disposer.
■It is recommended that a dedicated control valve be installed on the cold water line supplying water to this system. Make sure all water supply control valves do not have a backflow preventer in them.
■If you suspect elevated levels of chlorine in your water, it is recommended to use our water filtration system.
■The water pressure to the chilled water tank should be between a minimum of 30 psi (207kPa) and a maximum of 100 psi (689kPa).
■The chilled water tank may cause an increase in temperature in your cabinet when running.
■The chilled water tank has a refrigeration compressor, which may generate noise while running.
■The chilled water tank should only be installed in an upright position.
■The chilled water tank is intended only for chilling water.
WHAT YOU NEED TO GET STARTED
Equipment Required: (sold separately)
■ Cold water faucet | ■ Adjustable wrench |
■ | ■ Utility knife |
■ Dedicated control valve | ■ Tape measure / ruler |
Equipment You May Need: | ■ Hole saw / hole punch ■ Basin wrench |
If you will be installing a dedicated cold only water faucet and intend to use the sprayer hole in your sink for that faucet, you may need a basin wrench and a 1/8" plug or a 1/4" hose line cap (not supplied).
If you need to cut a mounting hole in your stainless steel sink, you may need a 11⁄4" - 11⁄2" hole saw made for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other than stainless steel.
2
