InSinkErator The Installation, Model HC1100, Connect to Cold Water Supply Line, Fill the Tank

The Installation, page 4 of 5

Model HC1100

Completely insert 3/8" polyethylene tubing from outlet side of filter head into 3/8" to 1/4" quick-connect "Y" fitting. Completely insert both dispenser faucet copper tubes (marked with white tape and unmarked) into the quick-connect "Y" fitting.

To remove a tube from its quick-connect fitting, depress the release ring into the fitting and gently pull the tube away from the fitting.

8. Connect to Cold Water Supply Line

Supplied with the unit is a brass nut, ferrule and tube insert to connect the polyethylene tube from the input side of the filter to a standard 3/8" compression fitting. Other plumbing connections are possible – check with a qualified plumber should you have questions.

Slide the nut and ferrule over the tube and then push in the tube insert. Insert the tube into a standard 3/8" compression fitting (not supplied) and tighten. Be careful not to over tighten.

Note: Connect the filter to the cold water supply only.

9. Fill the Tank

Turn on the water supply. Push the dispenser’s HOT handle and hold it to fill the tank.

Nothing will happen until the tank fills up and water begins coming out of the faucet. The water will be cold because the

TANK IS NOT PLUGGED IN.

Run the faucet for 3 minutes to flush the filter before initial use.

11