InSinkErator HC1100, GN1100 The Installation, Care and Use of your new 1100 Series, adjustment

Models: HC1100 GN1100

1 17
Download 17 pages 58.2 Kb
Page 3
Image 3
The Installation, Care and Use of your new 1100 Series

The Installation, Care and Use of your new 1100 Series

In-Sink-Erator Hot Water Dispenser

Save this important safety information!

This product dispenses water at temperatures up to 212˚F, which is hot enough to cause severe burns. Caution should be exercised when installing and using this product. Under no circumstances is this product to be altered in any way other than that which is specifically addressed in these instructions. Doing so may void your warranty.

Premature connection of the unit to an electrical supply could result in a “dry start” condition, which could damage the unit and void your warranty. The unit must be completely installed and the tank must be completely full with water running from the dispenser before plugging the unit in to an electrical supply.

Do not under any circumstances use bleach, abrasive liquids, powders or scouring pads to clean the faucet as doing so could void your warranty. Occasional cleaning with a soft cloth and warm soapy water is sufficient.

A hot water dispenser, like any water heater, has limited life and will eventually fail. To avoid possible property damage, a hot water dispenser should be regularly examined for leakage and replaced when necessary. A drain pan plumbed to an appropriate drain is highly recommended in those applications where any leakage could cause property damage.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – When using electrical appliances, basic safety precautions to reduce the risk of fire, electric shock, or injury to persons should be followed:

1.READ ALL INSTRUCTION BEFORE USING THIS WATER HEATER.

2.This water heater must be grounded. Connect only to properly grounded outlet. See “GROUNDING INSTRUCTIONS” found on page 4.

3.Install or locate this water heater only in accordance with the provided installation instructions.

4.Use this water heater only for its intended use as described in this manual.

5.Do not use an extension cord set with this water heater. If no receptacle is available adjacent to the water heater, contact a qualified electrician to have one properly installed.

6.As with any appliance, close supervision is necessary when used by children.

7.Do not operate this water heater if it has a damaged cord or plug. If it is not working properly, or if it has been damaged or dropped.

8.This water heater should be serviced only by qualified service personnel. Contact nearest authorized In-Sink-Erator service agent for examination, repair, or

adjustment.

3

Page 3
Image 3
InSinkErator HC1100 The Installation, Care and Use of your new 1100 Series, In-Sink-Erator Hot Water Dispenser, adjustment