InSinkErator GN1100, HC1100 owner manual Specifications & Approvals, Grounding Instructions

Specifications & Approvals

Tank Electrical Specifications: 750 watts, 115 volts, 6.5 amps.

With 3-wire cord and 3 prong plug provided.

Tank Capacity Specifications: 1/2 Gal: 60 cups per hour

Tank Thermostat Specifications: Adjustable from 160˚-200˚F

F201 Chemical & Mechanical Reduction Filter Specifications: (Use replacement cartridge F-201R) This cartridge (included with the system) provides mechanical and chemical reduction of dirt/rust, taste/odor, chlorine and particulates.

Pressure: 30-125 psi	Temperature: 33˚F–100˚F
Flow Rate: 0.75 gpm	Capacity: 500 gallons

System is tested and certified by NSF International against ANSI/NSF Standard 42 for the reduction of Particulate Class I, Chlorine Class I, Taste and Odor.

Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under standard laboratory conditions, actual performance may vary.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty card for warranty. For service and parts, contact your local dealer or In-Sink-Erator directly at 1-800-558-5700.

Contaminant	Average	Product	Average	USEPA	NSF
Reduction	Influent ppm	Water ppm	Reduction	Recommendation	TEST
Taste/Odor/	2.10	0.05	97%	N/A	500180-00
Chlorine
Particulates	286667	1683	99%	N/A	500181-00

Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or private well water supply, water pressure of 30-125 psi, water temperature of 33˚F–100˚F . Except as noted, all testing performed at pH = 7.5±0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp:20˚±3˚C.

Contact an authorized In-Sink-Erator service agent for repairs or replacement components.

Grounding Instructions

Electric Shock Hazard. Using an ungrounded or improperly connected appliance can result in serious injury or death from electric shock.

This appliance must be grounded. This appliance is equipped with a cord having an equipment grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Please size electrical supply appropriately and check rating plate for electrical requirements. Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded.

4