Integra DTR-4.6 instruction manual First Time Setup, Speaker Setup, The main menu appears onscreen

DTR-4.6.book Page 36 Thursday, September 22, 2005 1:45 PM

First Time Setup

This section explains the settings that you need to make	4
before using the AV receiver for the very first time.

Speaker Setup

This section explains how to set the speaker settings.

Receiver 5

Enter

Setup

Speaker Configuration 6

Here you can specify which speakers are connected and their individual sizes.

For speakers with a cone diameter over 6-1/2 inches (16 cm), specify large, and for those with a diameter below this, specify small.

Cone diameter

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.
	The main menu appears onscreen.			7
2	Use the Up and Down [		]/[	]
	buttons to select “3. Speaker
	Setup,” and then press [Enter].
	The Speaker Setup menu appears.
3	Use the Up and Down [		]/[	]
	buttons to select “Speaker Con-
	figuration,” and then press
	[Enter].
	The Speaker Config menu appears.
	3-1.Speaker Config
	------------------------
	a.Subwoofer	:Yes
	b.Front	:Small
	c.Center	:Small
	d.Surround	:Small
	e.Crossover	:100Hz
	f.Subwoofer Mode
	:-----------

Use the Up and Down []/[ ] buttons to select “a. Subwoofer,” and then use the Left and Right []/[ ] buttons to select:

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

Use the Up and Down []/[ ] buttons to select “b. Front,” and then use the Left and Right

[]/[ ] buttons to select:

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

Note:

•If the Subwoofer setting in step 4 is set to No, this setting is fixed at Large.

Use the Up and Down []/[ ] buttons to select “c. Center,” and then use the Left and Right

[]/[ ] buttons to select:

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

Use the Up and Down []/[ ] buttons to select “d. Surround,” and then use the Left and Right []/[ ] buttons to select:

Small: Select if the surround left and right speakers are small.

Large: Select if the surround left and right speakers are large.

None: Select if no surround left and right speakers are connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

36